- Joined
- Mar 1, 2006
- Threads
- 134
- Messages
- 671
- Location
- Charlotte, NC
- Website
- www.mattison-consulting.com
I put my front axle seals in before I used the sst tool to set up the knuckles.
I think that the Factory service manual is saying that in order to use the SSt I am going to have to have them out.
Here is the piece that is in reference... in green.
Can I leave this piece out and use the seal as the peice...
Or I am being lazy and just need to remove the piece and do it right?
I think that the Factory service manual is saying that in order to use the SSt I am going to have to have them out.
Here is the piece that is in reference... in green.
Can I leave this piece out and use the seal as the peice...
Or I am being lazy and just need to remove the piece and do it right?
Last edited: