I finally had my drive shaft guy replace the ujoints in my rear shaft with OEM joints from CDan.
He installed them correctly with all the nipples facing the right direction and all.
But for some reason I cannot get too the nipple on the ujoint on the tcase side of the shaft with out dropping that side of the shaft.
I looked at the old joint and it looks like the nipple is at a different angle than the new one.
How can I get grease into that joint without have to drop it when it needs grease it is a PITA.
He installed them correctly with all the nipples facing the right direction and all.
But for some reason I cannot get too the nipple on the ujoint on the tcase side of the shaft with out dropping that side of the shaft.
I looked at the old joint and it looks like the nipple is at a different angle than the new one.
How can I get grease into that joint without have to drop it when it needs grease it is a PITA.