Transfercase Seals? (1 Viewer)

[Ezra]

I have a new clutch being put into my 73 FJ40, and while the transmissions is out I am going to have new gaskets put in. It was also suggested that I swap out the transfer case seals at the same time, but having a hard time deciphering which seals I need. It is just an Input and and Output seal correct?

Thanks all.

 

[73FJ40]

@Ezra

Here's an illustration of the transfer case. It may be a challenge to replace the three seals shown (transfer input shaft at transmission, transfer outputs, front and rear) without a number of gaskets, which ends up leading to an overhaul.

 

[Ezra]

@Ezra

Here's an illustration of the transfer case. It may be a challenge to replace the three seals shown (transfer input shaft at transmission, transfer outputs, front and rear) without a number of gaskets, which ends up leading to an overhaul.

Thanks, I was confused about the two output shaft seals. Assumed there was only one output shaft.

I am having the gaskets replaced as well.

Thanks for the info.