Guys - Had a leak in the speedo gear housing so pulled the e-brake and housing and re-sealed everything. While I was in there, I milled the lip inside the speedo housing and did the two seal trick. My reseal of the housing cured that leak but now I appear to be leaking out of the double sealed area around the e-brake drum. There is no groove when I run a fingernail across the flange and the seals are in a different place than stock so the explanation evades me. They are brand new seals from Cruiser Outfitters. Any ideas??
Here are a few pics:
Leak apparently coming from seal and dripping down:
Untitled by jeff elliott, on Flickr
Inside of drum clearly wet with 90w:
Untitled by jeff elliott, on Flickr
Two seals stacked and pressed in housing:
Untitled by jeff elliott, on Flickr
Here are a few pics:
Leak apparently coming from seal and dripping down:
Untitled by jeff elliott, on Flickr
Inside of drum clearly wet with 90w:
Untitled by jeff elliott, on Flickr
Two seals stacked and pressed in housing:
Untitled by jeff elliott, on Flickr