So I ordered the bell housing bolt kit from SOR for my Landcruiser (1969). Excited, as I had been waiting 3 months to finish everything clutch-wise to mount the transmission finally, yet I tried the bottom bolt holes and they didn't fit. The top bell housing/tranny bolts are 19mm and fine thread. However, and this is where my brain starts to melt, the bottom bolts that we threw in there (were old engine mount bolts) don't have enough clearance for a socket once they get down to the head and are almost seated. I tightened them as much as I could but there is still 1/4 to go for them to be tight. So obviously there's a different bolt head for that bolt? I need some guidance, please.
The bottom bolt holes appear to be 17mm and coarse thread. I can't find the schematic and correct bolts apparently.
thanks for any help in advance, and Happy Thanksgiving!!
The bottom bolt holes appear to be 17mm and coarse thread. I can't find the schematic and correct bolts apparently.
thanks for any help in advance, and Happy Thanksgiving!!