Trail Gear weld on sliders (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 27, 2020
Threads
24
Messages
252
Location
fresno
I am looking at ordering some Trail Gear sliders. i am looking for some pics on how people built them around there catalytic converters? pics would be greatly appreciated.
120002-1-kit.jpg
 
10-4. Pics from mine won’t be of any help then, but the one support in the area of the cat was to bent to go around it. 5 supports per side opposed to 3. My exhaust is completely inside the frame rails now.
 
10-4. Pics from mine won’t be of any help then, but the one support in the area of the cat was to bent to go around it. 5 supports per side opposed to 3. My exhaust is completely inside the frame rails now.

thank you. I saw some pics they other day but i cant seem to find them i tried searching.
 

Here’s my posting. Building another set again on another rig.
I had one set that went through the rubicon with no issues.
 
I'm welding up a set now but for a 96 with inline cats. I'm using some 1"square tube cut to 45° to a 1/4" plate to protect the cats.

The square stuff is a little easier to work than dom. Not sure about the exhaust on a 3f but you could try getting some more tube and mock something up.
 

Users who are viewing this thread

Back
Top Bottom