I am going to pull my camshafts soon. I have done the cylinder head before so i have done this but i had a FSM handy. Does anyone have a link to any FSM instructions for removal of cam shafts? All i really need are torque spec for cam caps and the criss cross tightening pattern, torque spec on cam gears and torque spec on distributor gear if i remember correctly.
If i remember correctly just line it all up at TDC, mark distributor, line up dots on cams, line up crank shaft. Zip tie gear really well. Remove distributor, distributor drive gear, cam chain gear. Then loosen caps in criss cross, remove exhaust first right, hen intake. Sounds easy, what could go wrong. I assume tensoner needs to come out as well.
If i remember correctly just line it all up at TDC, mark distributor, line up dots on cams, line up crank shaft. Zip tie gear really well. Remove distributor, distributor drive gear, cam chain gear. Then loosen caps in criss cross, remove exhaust first right, hen intake. Sounds easy, what could go wrong. I assume tensoner needs to come out as well.