Tire and wheel options (1 Viewer)

[bubba5320]

As a follow-up to my last post this is what I am trying to achieve. Any suggestions appreciated. I am trying to set up my 80 series with aftermarket front and rear bumpers not real heavy not carrying a spare tire nor Jerry cans just the bumpers and no winch. Stock height after any sag maybe and OMU 3/4 lift? And I wanted to run tires that are approximately 33 x 12.5. Would be nice if tires sat with wheel offset to produce a 1 to 1.5 inch wider stance. Hope this makes sense and thanks for any advice ideas.

 

[cruzinfj1]

Official 35" and under!! Post pictures!!

This thread is for 35" and under tires on your rigs. Post your pictures and specs! :bounce::cheers::flipoff2:

forum.ih8mud.com

 

[LandLocked93]

33x12.4 on 16x8 w/-12mm offset and 4.25" backspace.
If you have flares, this is about as wide as you can go before going outside them.

 

[bubba5320]

Nice. This is info I was looking for. What tires and wheels are you running by the way and any spacers, lift? Thanks.

 

[LandLocked93]

Nice. This is info I was looking for. What tires and wheels are you running by the way and any spacers? Thanks.

Tires are Falken AT3W 285/75-16, wheels are Vision 84 D-hole steelies. No spacers.