Tips on body work for fj62

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 19, 2005
Threads
203
Messages
4,691
Location
South west utah
My fj62 is full of rust and dents, I have been thinking about taking a grinder and body filler to it and where it is real bad patching with new metal. I thought someone might have some tips.
 
I'm in the middle of the same thing....


rust is very bad... door sills, rocker panels...

If u can get away with patching, fine... I'm having to cut away whole pieces of body and weld new ones on (rear quarter panels, rocker panels, rear door sills, outer wheel wells....

lots of work, but it'll be worth it when i have the only new 1983 Land Cruiser in Wisconsin. ANd if i do my rust proofing right, maybe i wont have to do it again a few years.


Fred
 
What you want to do is get an angle grinder. Don't us a grinding disk, the metal is too thin and you just will make the paint bubble on the other side, and it will start to rust there. For use with the grinder you want 3 types of attachments; a thin cutting disk, flat sanding disk and backing pad, wire wheel. Where you have cancer use the first to cut it all out and weld in new metal. Where you have only surface rust, remove it with the sanding disk, then go over really well with the the wire wheel to clean out any pits. Then slightly hammer down you welded joints and cover with appropriate filler to get the right contour.
Good luck.
ERICH
 
if you want a cheap fix you can do wat i did. Buy sum chicken wire and go to a buddies truck and form it as close as you can. , Grind clean outside ,Rust bullet o watever, then on the grind the back side then Fiberglass to the chicken wire to the back. (get the epoxy through) Once this is done bondo the out side. use an artist's touch to fill and shape the excess amount. I couldn't find a rear quarter where the bumper was curved in so i did this (and in some other places. Sounds like alot ... because it is... but it is a good fix if you don't have the metal.
 
Back
Top Bottom