Thrust washers needed, Aussie Locker Install RTH needed (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 29, 2011
Threads
75
Messages
3,475
Location
Phoenix, AZ
I am in the middle of installing an Aussie locker in my FZJ80 and need to replace a thrust washer, it's too thick and outside of tolerance. If anyone bought a kit to install theirs or knows where I can go to get washers today, I would appreciate it. Text would be great as I may not be sitting by my computer.
Bryan
 
Last edited:
I think I do still have the washers from my kit I used.
 
Thanks everyone. I ended up talking to @Tools R Us and he coached me through methods of thinning down my existing thrust washers. I ended up at .007" with an acceptable range of .006-.02", so about as good as one could hope for.
Thanks to @Rudster for the referral and @Tools R Us for the phone call help.
 
Hi Guys,

Sorry, just saw your post. Sometimes we see carriers that are out of spc, so we've some up with a line of custom thickness thrust washers, available on our website. Torqmasters.com
 

Users who are viewing this thread

Back
Top Bottom