Throttle Knob Route early 60s FJ40 (1 Viewer)

[bosco66fj40]

Does anyone know the route the throttle knob takes on an early 60s fj40?

 

[JohnnyC]

The hand throttle cable goes to the carb

Found this thread for an early cruiser … kinda the same for the 60’s fj40’s as well

hand throttle diagram

do any of you have a diagram or photo of how the hand throttle cable hooks up to the carburetor or throttle linkage? The PO had disconnected mine, and I just want to be sure i reconnect it properly. Thanks! Destin

forum.ih8mud.com

 

[JohnnyC]

Here’s another…

Hand throttle cable to '67 carb throttle lever

Getting the original single barrel carb going- after 10 minutes of rough acceleration it's now running great. Trying to figure out how the hand throttle cable attaches to the throttle lever. The last tidbit in the box of parts is a cable connector (shown in my hand) that is a little different...

forum.ih8mud.com

Btw later hand throttle cables went to the gas pedal … if your cable is quite short it may have been modified to go to the pedal

 

[ToyotaMatt]

Does anyone know the route the throttle knob takes on an early 60s fj40?
View attachment 3241509View attachment 3241510

YES ,

it goes STRAIGHT through the firewall inline with the D-GROOVE hole in the main outer , inside CAB metal dash switch panel


you Deveite from this path you will NOT get it routed correctly ...

 

[bosco66fj40]

Thanks!

 

[bosco66fj40]

Here’s another…

Hand throttle cable to '67 carb throttle lever

Getting the original single barrel carb going- after 10 minutes of rough acceleration it's now running great. Trying to figure out how the hand throttle cable attaches to the throttle lever. The last tidbit in the box of parts is a cable connector (shown in my hand) that is a little different...

forum.ih8mud.com

Btw later hand throttle cables went to the gas pedal … if your cable is quite short it may have been modified to go to the pedal

I found the image that shows how it attaches to the carb.

 

[locklaw]

On a RHD early 40 the choke and throttle are next to each other. The choke, throttle and temperature sender wire all come through this grommet on the firewall and attach as stated above -