The Honey Badger (Story/Build of my FJ62) (1 Viewer)

[Kleatus]

And it runs! (2 weeks ago?) Started it up after fumbling through HP tuners to turn off VATS and a few other things. Still have to clean up wiring. This isnthe whole GM harness including main fuse block .

 

[Kleatus]

Going to run GM style nylon fuel tube for everything. Silver soldered some new hardline into the pump module. Had to drill out the rivet for the (+) wire to remove it and keep from melting it. Tapped the brass stud for a new SS screw to replace the rivet.

Made a fan shroud last night. Far from "nice" but it will work. I had a bunch of pieces of ~9" wide sheetmetal with plastic wrap that needed removed and some very tenacious paint. It would have been nice to start with a full sheet and cut tabs into everything rather than spot welding little angles here and there. Maybe later I'll actually draw up a pattern and cut it out on a plasma table so it's only one piece.

 

[cruisermatt]

I still need to send you a transmission harness!

 

[HemiAlex]

Let’s roll.

 

[Kleatus]

Let’s roll.

Getting close man! I think it's happening.