Is most pieces are flat.
My rocker panels have taken a beating and the driver’s side had some cancer in them.
Cut out the bad spot and trim 2 inches from the bottom of the fender and the rest of the rocker.
Cut and shape new piece to fit the hole then tack weld in place. I used an extra side panel from a Honeywell cabinet I got for free from work. Can’t pass of a flat piece of 16gage metal.
Finish welding and grind the excess weld off.
Cover with some primer until I can paint.
I wanted to clean up this area before I make and install sliders so I can keep the future damage to this area at a minimum.
My rocker panels have taken a beating and the driver’s side had some cancer in them.
Cut out the bad spot and trim 2 inches from the bottom of the fender and the rest of the rocker.
Cut and shape new piece to fit the hole then tack weld in place. I used an extra side panel from a Honeywell cabinet I got for free from work. Can’t pass of a flat piece of 16gage metal.
Finish welding and grind the excess weld off.
Cover with some primer until I can paint.
I wanted to clean up this area before I make and install sliders so I can keep the future damage to this area at a minimum.