4Cruisers
SILVER Star
- Thread starter
- #21
Thanks for the input, I'm pretty sure that's what I'll do.I went with washers but I think milling is the better approach. I used OEM manifold washers for appropriate diameter and consistency of thickness. Cut them in half and JB Welded the 1/2 washers to the Al intake manifold. The JB seemed to hold well but I knocked a few off while mounting, even so I don't have any leaks. Another consideration is that in using the 3FE exhaust that the 14 mm end bolts may be too short. If the 3FE manifold is milled to match the intake thickness this will not be an issue.