I need a good tap and die set. Never bothered to buy one, could've used one a coupla times, but the local hardware store doesn't carry any taps or dies. (pathetic isn't it).
Any you would recommend, and what can I expect to pay. To start I only need the typical 1/8, 1/4, 3/8, 1/2 NPT fittings for making the manifolds and fittings for my on board air, but if there is a good complete set maybe with some metrics I would be interested in biting the bullet so I don't have to run to the store everytime i need to run a die over a marred bolt, etc.
These will see only limited use and I can't afford Snap On.
Any you would recommend, and what can I expect to pay. To start I only need the typical 1/8, 1/4, 3/8, 1/2 NPT fittings for making the manifolds and fittings for my on board air, but if there is a good complete set maybe with some metrics I would be interested in biting the bullet so I don't have to run to the store everytime i need to run a die over a marred bolt, etc.
These will see only limited use and I can't afford Snap On.