Steering Shaft (1 Viewer)

[wtmtnterror]

I'm working on a power steering conversion on my 74 FJ40. I have a gear box (36 spline ordered from Napa) and I have this steering shaft...http://store.summitracing.com/defau...eywordSearch&DDS=1&N=115&target=egnsearch.asp

It works with the box fine but the other end where it meets the steering column is too large. This end would be 13/16 and 48 splined?

So what do I need to make this work?

 

[LC_Hamma]

Sounds like you need a male splined section to fit into the Borgeson joint. Then, on the LC shaft, you would need a coupler (w/ set screw) to mate them. I would think AA has the parts to complete this. Or would have better advise than me....