I checked my bushings, and they were totally shot, super torn, so i commenced replacement.
I was able to get the passenger side out with my air hammer, the driver side though...different story.
I air hammered it a good bit, but the shell of the bushing was pretty much cut through by my air hammer, and the center of the bushing fell out. Leaving the rest of the shell hung up inside the rack.
Both being aluminum and malleable, I've kinda buggered up the whole area. I'll be throwing poly bushings in, so im not too worried as I can clean it up.
Buy my issue is, how the hell can i get this shell out? I've been trying for an hour and its just stuck in there. Any tips/advice?
I was able to get the passenger side out with my air hammer, the driver side though...different story.
I air hammered it a good bit, but the shell of the bushing was pretty much cut through by my air hammer, and the center of the bushing fell out. Leaving the rest of the shell hung up inside the rack.
Both being aluminum and malleable, I've kinda buggered up the whole area. I'll be throwing poly bushings in, so im not too worried as I can clean it up.
Buy my issue is, how the hell can i get this shell out? I've been trying for an hour and its just stuck in there. Any tips/advice?