Spacer Searching (1 Viewer)

[Jerome3]

Im looking to add some front spring spacers to level the beast out, ive put it off long enough and with a front bumper on the horizon it will only become more of an issue. I searched and looked at a number of spacers and feel more comfortable with an aluminum and more permanant spacer like the ones FZJFillmore made in this thread https://forum.ih8mud.com/showthread.php?t=53488 as well as the silver darkar rings also shown in that same thread vs a rubber mr gasket type which will compress. Soooooooo what i askin is who sells aluminum spring spacers such as these or similars kinds?? as fillmore only made a few sets for a few lucky individuals.
thanks,
Jerome

 

[elmariachi]

Have you contacted Fillmore to see if he has any? That's where I got mine.

 

[Jerome3]

doin it good idea

 

[PKP80]

definitely, make sure that you get it so that it drops the bumps stops with the spacing

 

[Jerome3]

thats what i liked about fillmores. if you used a ring type spacer and raised it say 1in you would need to lower your front bumpstops 1 inch as well correct?

 

[PKP80]

correcto

 

[Trunk Monkey]

I just got done with another run of them and they all sold. I'll do another batch in a few months. Being a "vendor", even on one small part, has been a bit of an eye opener for me. People saying they'll take a set and then not following through on paying. I thought about doing pre-pay, but don't want to get into a situation where I've got people's money and then things take longer than I'd planned. Anyway, sorry to be chatty, keep an eye in the vendor's section.

 

[Trailbus]

I took off my spring purch, traced a patern on a chunk of cardboard, and gave it to a local fabricator (friend of mine) who designed/cut/welded up a set in an hour. Cost me $50 +bolts. They are the same design as these but with a square chunk of tube in the middle. I went for a 2" spacer and it leveled my Heavy front/med rear truck.