- Joined
- Apr 14, 2004
- Threads
- 1,391
- Messages
- 35,237
- Location
- 818-953-9230
- Website
- www.marksoffroad.net
I picked up a brand new Bestop softtop and doors a few weeks ago that was missing a couple of pieces of hardware. I think I can scrounge up handles and hinges for the doors, but the two rods that go over the tops of the doors between the forward bow and the windshield frame are both missing.
I am pretty confident that I can reproduce those two pieces, as IIRC, they are based on a simple 3/8" rod that has a right angle bolt at the windshield end and a washer where it meets the bar that runs up the back side of the door.
What I need is a picture with measurements of the overall length of the rod, the spacing between the bolt at the forward end and the washer at the back of the door.
TIA
I am pretty confident that I can reproduce those two pieces, as IIRC, they are based on a simple 3/8" rod that has a right angle bolt at the windshield end and a washer where it meets the bar that runs up the back side of the door.
What I need is a picture with measurements of the overall length of the rod, the spacing between the bolt at the forward end and the washer at the back of the door.
TIA