1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

SOA

Discussion in 'HardCore Corner' started by cali-cruiser, Feb 18, 2004.

  1. cali-cruiser

    cali-cruiser

    Messages:
    234
    Likes Received:
    0
    Joined:
    Nov 15, 2003
    Location:
    arnold, CA
    I know this has already been covered probably, but does anyone make SOA perches that can be bought or do most of you guy make your own. I'd just like to maybe see some ideas. Also has anyone ever done a SOA with 4" springs. I was thinking of doing it but I don't want it to be too big so I was thinking of taking out a few leafs.

    Thanks :cheers:
     
  2. Mace

    Mace rock scientist.. Staff Member s-Moderator

    Messages:
    21,331
    Likes Received:
    1,767
    Joined:
    Feb 17, 2002
    Location:
    Las Vegas
    Look up dodge spring perches...

    You can fit 42's with some cutting and stock springs. Why on earth would you want to use 4" lift springs!!!
     
  3. cali-cruiser

    cali-cruiser

    Messages:
    234
    Likes Received:
    0
    Joined:
    Nov 15, 2003
    Location:
    arnold, CA
    Because I already have them. I was just asking!!!
    What about the front end were its half way on the pumkin.
    thanks :flipoff2: :flipoff2:
     
  4. Mace

    Mace rock scientist.. Staff Member s-Moderator

    Messages:
    21,331
    Likes Received:
    1,767
    Joined:
    Feb 17, 2002
    Location:
    Las Vegas
    Grinder takes care of the pumpkin side nicely.

    Or you can cut off the original spring pad and relocate it to the top of the axle..
     
  5. cali-cruiser

    cali-cruiser

    Messages:
    234
    Likes Received:
    0
    Joined:
    Nov 15, 2003
    Location:
    arnold, CA
data-matched-content-rows-num="2,1" data-matched-content-columns-num="1,4" data-matched-content-ui-type="image_stacked" data-ad-format="autorelaxed">