tackling yet another chainsaw finetuning.
This one was working fine last time I tried it. Just now, with nothing changed except gas put in, it will start but won't keep running unless I keep the choke on half way and even then it's iffy if I play with the throttle.
Tellingly, perhaps, I don't see much gas at all in the little flex priming bulb, whereas I would assume it should be mostly full. Am in correct on that? If not, that would suggest that the fuel intake is clogged, I take it.
This one was working fine last time I tried it. Just now, with nothing changed except gas put in, it will start but won't keep running unless I keep the choke on half way and even then it's iffy if I play with the throttle.
Tellingly, perhaps, I don't see much gas at all in the little flex priming bulb, whereas I would assume it should be mostly full. Am in correct on that? If not, that would suggest that the fuel intake is clogged, I take it.