SM420 conversion hardware (1 Viewer)

[73lndcrsr]

I need to verify the hardware need for the conversion. I understand the write ups and the gaskets, bearings and seals. I need information on the bolts other than the 3/8 for the plate to tranny.

What is the size of the studs and long bolts pictured on the Spaceghost page?

Thanks for the help.

 

[SpaceGhost]

5" grip length, 7/16C thread. 3 needed.
Studs are Napa st52, 7/16Fx7/16Cx2" 2 needed.
7/16F lock nuts, get the crimped ones, not teflon lined. 2 needed.

Flat washers and lock washers, for the long bolts, flat for the short ones.

 

[73lndcrsr]

Thanks again. I was getting down to the last few pieces. This will get me what I need.