slow jet size question (1 Viewer)

[bsilva132]

I recently rebuilt my carb (73-74) with a hyster rebuild kit. Unfortunately I was not able to use most of the new jets as they were the wrong sizes. I scrounged up most of the correct sizes from my spares pile, but the one I did not have was a 0.50mm primary slow jet, which according to Ed Cook's write up in the tech section, is the correct size. I have a 0.60mm primary slow jet that I could use, but I am not sure if that is going to casue problems. Any advice? Or does anyone have a 0.50mm primary slow jet they can spare?

Thanks,
Brian