DivByZero
SILVER Star
Can it be done? I'm trying to replace the exhaust on my HZJ80. The rearmost section of the exhaust pipe runs over the frame, in a narrow gap between the body and frame. Other people have been able to slip the pipe through at a magic angle, which I've discovered doesn't work if you have the factory sub fuel tank like I do.
I'm considering seeing if I can loosen some of the body mounts, and jack up the rear of the body off the frame by around 1cm in my driveway, so I can slip the old tailpipe out, and slip the new one in.
Thougts? Opinions? I basically want to hear all the things that might make this difficult or impossible, rather than discovering them halfway through the attempt. And if anyone has done anything similar, please share any advice which you can offer. Thanks!
I'm considering seeing if I can loosen some of the body mounts, and jack up the rear of the body off the frame by around 1cm in my driveway, so I can slip the old tailpipe out, and slip the new one in.
Thougts? Opinions? I basically want to hear all the things that might make this difficult or impossible, rather than discovering them halfway through the attempt. And if anyone has done anything similar, please share any advice which you can offer. Thanks!