Last night I noticed a slight leak from under the head near the distributor. There is a small casting feature on the head and from searches it appears the gasket gets skinny here. The engine has good compression otherwise. This may have been there for a long time and I never noticed it because of gunk I figured was from the old leaky stamped valve cover or the side cover.
Seems to be oil. If I spray it I can see a tiny bubble pulsing out.
Retorque head bolts? Pull the head? Run it?
Here is a photo of the spot in question from when I got the rig
The photo below is not mine but to show where I am seeing this (mine is an F155)
Seems to be oil. If I spray it I can see a tiny bubble pulsing out.
Retorque head bolts? Pull the head? Run it?
Here is a photo of the spot in question from when I got the rig
The photo below is not mine but to show where I am seeing this (mine is an F155)