- Location
- United States
I realize not everyone likes to cut up their harness' but am hoping someone either has a damaged harness or doesn't care
What I'm looking for, is the a chunk of the main harness that runs back along the USDS quarter panel. Looking for a section form about a foot to the right (towards the front) of the gas filler pipe, to underneath the truck where the harness comes out of the quarter and cut right before the harness splits off to the locker/brake wiring (by the body ground bolt in the rear). And the fancy grommet too
There are what appears to be 2 main connectors in this section below where to stock jack sits., one with about 20 wires (BQ1), which I ended up melting. Some other connectors that go up the pillar I don't really care about.
I can provide pictures of what I need and where to cut if you have something lying around.
Thanks
Ryan
What I'm looking for, is the a chunk of the main harness that runs back along the USDS quarter panel. Looking for a section form about a foot to the right (towards the front) of the gas filler pipe, to underneath the truck where the harness comes out of the quarter and cut right before the harness splits off to the locker/brake wiring (by the body ground bolt in the rear). And the fancy grommet too
There are what appears to be 2 main connectors in this section below where to stock jack sits., one with about 20 wires (BQ1), which I ended up melting. Some other connectors that go up the pillar I don't really care about.
I can provide pictures of what I need and where to cut if you have something lying around.
Thanks
Ryan