1973Guppie
Supporting Vendor
- Joined
- Jan 31, 2003
- Threads
- 952
- Messages
- 10,227
- Location
- "the whale's vagina", CA
- Website
- www.noahsarkstlc.com
I am planning on tying in my rollbar to my frame here fairly soon and was looking over my seat bracketry today on my 73 fj40. It is basically the stock fj seat frame that has been altered somewhat, tabs welded to, cut in places, etc, in order to fit my aftermarket seats and tuffy center console. For the most part it is basically the stock setup. My question is how safe is this setup? I know many bolt the seats to a setup that is tied into the rollbar and while this is probably the best way to go, I don't want to have to go this route if my setup is safe enough already. I am using all the same stock threaded holes etc. I don't do major hard core wheeling and I am more concerned about on street high speed safety, etc. Any opinions are appreciated.
Noah
Noah