Rubber grommet (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 15, 2005
Threads
24
Messages
66
I installed a new speedometer cable, and cannot CANNOT get that 1.5 inch rubber grommet properly seated into the 1 inch hole in the firewall.

Anyone have any tips/tricks to do it?
 
Little bit of soap *might* make it slip into place a bit easier...


They can be a pain...


Good luck!


-Steve
 
Is it also common to find a good amount of oil/transmission fluid on the backside of the gauge panel where the speedo cable hooks into the panel? Should the gasket at the transfer case connection prevent oil from entering into the speedo cable?
 

Users who are viewing this thread

Back
Top Bottom