RTH: Iron Pig skid install (1 Viewer)

[SteveNJ]

Ok so where the heck do you jack/support the tranny to get this thing on?

I tried up on the bell and when the cross piece started to come down the tranny dipped a lot 3-5 inches by the cross member)

But if you support closer to the cross member you are on the pan (which cant be good) but even if that is ok, there isn't room to put the skid in since it covers the whole pan (where you'd be jacking).

Is by the bell ok with 3-4 inches of drop (if not more) where the cross member is or am I missing something here?

 

[SteveNJ]

NVM, apparently I turn into a blithering idiot without enough sleep. Supported the back too and was done in 15mins.

 

[Finnyfam60]

NVM, apparently I turn into a blithering idiot without enough sleep. Supported the back too and was done in 15mins.

pics or it didnt happen