RTH: Crankshaft pulley bolt (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

20200928_170424.png

(I put the holes on the wrong side so I had to rework it, otherwise no welding would be needed.)
 
Done a bunch of them with a 1/2" I R old school gun. has never failed.

My AirCat took mine right off.....but it does take a pretty good impact to do it.
 
Disagree. I have had several that were very stubborn for unknown reasons. One I had to use a torch on the bolt and run a straight line to the largest air gun I had. Had to take off the front clip. Never had one that bad again but have had a few where the starter method doesn't work
"Should work" not "will work every time".
 

Users who are viewing this thread

Back
Top Bottom