hi all,
I am replacing the filler neck on my 1994 80 series.
I have the old one out. It was so rusted I ripped it in half to get it out.
Looking in past threads I see the new replacement has to be sectioned to install it unless I pull the body off the frame. (Thanks Toyota) That's not happening.
I am looking for pictures or advise on how others have cut this in the past. I couldn't find any photos.
Or better yet, a magic trick showing how to get this installed in one piece. Haha.
Living in the rust belt is so much fun.
Thanks,
Joe
I am replacing the filler neck on my 1994 80 series.
I have the old one out. It was so rusted I ripped it in half to get it out.
Looking in past threads I see the new replacement has to be sectioned to install it unless I pull the body off the frame. (Thanks Toyota) That's not happening.
I am looking for pictures or advise on how others have cut this in the past. I couldn't find any photos.
Or better yet, a magic trick showing how to get this installed in one piece. Haha.
Living in the rust belt is so much fun.
Thanks,
Joe