Thanks to your posts I was able to easily put in the new sensors that CDan sent me.
Reset the code and a few days later I'm get the 'EGR flow insufficient' code.
I've looked through previous posts on this code and found some good info.
But with this happening RIGHT after I replaced my 02 Sensors I'm checking with you all to see if this is indicative of anything.
Thanks for any ideas, input, direction.
Steve, Denver
97 LX450 140k
Reset the code and a few days later I'm get the 'EGR flow insufficient' code.
I've looked through previous posts on this code and found some good info.
But with this happening RIGHT after I replaced my 02 Sensors I'm checking with you all to see if this is indicative of anything.
Thanks for any ideas, input, direction.
Steve, Denver
97 LX450 140k