removing an f (1 Viewer)

[tbk125]

iv read several threads but can someone give me some quick tips or words of advise because im in my garage right now trying to remove the f out of my 1970 fj55, with just the bellhousing and not with the trans, i read there were four bolt that held the bell housing to the tran which i removed but is that all? excuse my ignorance but im young and only self tought

 

[Pighead]

Front motor mounts, rear motor mounts (which are on the bellhousing). Throttle linkage, don't forget the choke cable...

 

[merlinridesagain]

I do remember having to pry the two apart as the input shaft was a tight fit. I'm not sure how easy this is when just pulling the engine. I went with pulling the entire engine/trans/xfer out and then separating them out on the floor. That way I could keep them level and pull them apart.