I have all the wiring set up, relays are in and working for reverse lights and 12V house battery charging.
Brake control wires are run up under the dash and loomed, waiting for me pick a good spot for the brake controller.
Where I'm struggling is where the heck to put the little magic dial for the REDARC trailer brakes.
Would anybody that runs one of these be willing to share where you put the dial?
I have two blank switch locations left and they are both bespoken for future lighting needs.
The two most promising locations are in the flat of the shifter console next to the 2nd Start and Power buttons, or up on the center console to the left side of the latch to get in the lower bucket. The subwoffer is disconected, so if it's in the way for the upper location, it will come out.
Brake control wires are run up under the dash and loomed, waiting for me pick a good spot for the brake controller.
Where I'm struggling is where the heck to put the little magic dial for the REDARC trailer brakes.
Would anybody that runs one of these be willing to share where you put the dial?
I have two blank switch locations left and they are both bespoken for future lighting needs.
The two most promising locations are in the flat of the shifter console next to the 2nd Start and Power buttons, or up on the center console to the left side of the latch to get in the lower bucket. The subwoffer is disconected, so if it's in the way for the upper location, it will come out.