Rebuilding my 80's 1fz and not sure where this part go's
- Thread starter Bobmeetsbob
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
SmokingRocks
Don't focus on the cost of this addiction
it goes in the engine
SmokingRocks
Don't focus on the cost of this addiction
On a serious note though, it looks like some kind of slider valve. Like what your transmission has in it that moves back and forth directing fluid down different channels. I thought sender unit first but theres no threads on it. Anyone else?
Is that the only one?
Is that the only one?
- Thread starter
- #5
Iv check the oil pump and oil cooler it doesn't go in any of them
Did you work on the power steering pump? It looks like a part from the power steering pump.
Picture from https://forum.ih8mud.com/threads/fj80-and-lx450-ps-pump-rebuild.467550/#post-6457223
Picture from https://forum.ih8mud.com/threads/fj80-and-lx450-ps-pump-rebuild.467550/#post-6457223
Last edited:
- Thread starter
- #7
It dose look exactly the same but I never pulled the power steering apart
- Thread starter
- #8
Sorry you were right thank so much man I was worry it was behind the timing case and I only put that on yesterday thanks for every ones input as well
