Reassembling a 1979 Hardtop - Does anyone know where to source these rubber seals? (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 7, 2022
Threads
7
Messages
31
Location
Signal Mountain, TN
Disassembled the hardtop from my '79 to have the headliner replaced, replace the top seal, drill out and retap some rusted/busted bolts, and just give it an al around cleaning, etc.

The rear cross member (over the ambulance doors) has these two rubber seals (one on either side) that go in between the crossmember and the left and ride sides. They're held on with 3 (each) small flat-headed pop-in clips.

Anyone know where to source the rubber seals from (cause these things are shot)? I can probably reuse the clips or even use a gasket adhesive to adhere the seals. Any help would be greatly appreciated!

IMG_5527.JPG
 
No doubt; it's easier for me to get parts for my 1977 FJ40 than my 1995 FJZ80.
 
No doubt; it's easier for me to get parts for my 1977 FJ40 than my 1995 FJZ80.

Consider the 80 series was produced from 1990-1997 in a single body style. While the 40 series was produced from 1961 until early 1986 in multiple versionbs. 40 series was the main model Toyota made during that time. World wide the 70 series was main model produced and sold around the world.
 

Users who are viewing this thread

Back
Top Bottom