Disassembled the hardtop from my '79 to have the headliner replaced, replace the top seal, drill out and retap some rusted/busted bolts, and just give it an al around cleaning, etc.
The rear cross member (over the ambulance doors) has these two rubber seals (one on either side) that go in between the crossmember and the left and ride sides. They're held on with 3 (each) small flat-headed pop-in clips.
Anyone know where to source the rubber seals from (cause these things are shot)? I can probably reuse the clips or even use a gasket adhesive to adhere the seals. Any help would be greatly appreciated!
The rear cross member (over the ambulance doors) has these two rubber seals (one on either side) that go in between the crossmember and the left and ride sides. They're held on with 3 (each) small flat-headed pop-in clips.
Anyone know where to source the rubber seals from (cause these things are shot)? I can probably reuse the clips or even use a gasket adhesive to adhere the seals. Any help would be greatly appreciated!