so the rear wiper was hit by a tree branch, and now just sorta hangs there, its on the post, and moves freely, but doesnt work. is this just a stripped bushing perhaps?
rear wiper (1 Viewer)
- Thread starter COChef
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
the splines on the inside of the arm might be stripped. Take it off and see. For a cheap fix you can use JB weld. I used JB weld on mine about 5 years ago and it is still holding. You could find another arm for the same price as JB weld though
- Thread starter
- #3
bushing, stripped. jb weld sounds like a good fix. Thanks!
If you go the JB weld route, make sure the inside of the arm is clean and burred a little. This gives the epoxy a ledge to grab onto.
- Thread starter
- #5
fixed it last night roughed it up w some 80 grit applied jb weld, good as new-ish. well at least it works now.
thanks for the tips folks.
thanks for the tips folks.
