Need some ideas here from the group.
Here is what i have. My rear tires have started wearing bad like the front tires would if it was out of alignment. It all started about 3 weeks ago after i rotated the tires. I did not use a impact just tighten by hand ( breaker bar and socket ). I noticed it started getting real unrully on the road also. The truck is running 35's but has been for years now. I took it to my alignment shop and had them check the rims for a bent one and an alignment at the same time. all were fine and the alignment is good now but nothing good yet. I am getting ready to put it on stands tomorrow and go over it with a fine tooth comb but maybe someone else has already seen this before and can point me in the right dirrection. The front tires are wearing fine.
I looked to see if my rear axle has moved but it has not. The center pin is still in the center of the hole .All of the U bolts were tight also. It has not been offroad for too long now so nothing like that. I also just took both sides of the rear axle out to replace all of the lug studs because i broke a few off. This was after this started though.
Thanks for any and all ideas.
Here is what i have. My rear tires have started wearing bad like the front tires would if it was out of alignment. It all started about 3 weeks ago after i rotated the tires. I did not use a impact just tighten by hand ( breaker bar and socket ). I noticed it started getting real unrully on the road also. The truck is running 35's but has been for years now. I took it to my alignment shop and had them check the rims for a bent one and an alignment at the same time. all were fine and the alignment is good now but nothing good yet. I am getting ready to put it on stands tomorrow and go over it with a fine tooth comb but maybe someone else has already seen this before and can point me in the right dirrection. The front tires are wearing fine.
I looked to see if my rear axle has moved but it has not. The center pin is still in the center of the hole .All of the U bolts were tight also. It has not been offroad for too long now so nothing like that. I also just took both sides of the rear axle out to replace all of the lug studs because i broke a few off. This was after this started though.
Thanks for any and all ideas.