I replaced the window runs on the rear quarter windows and noticed when washing it there was water on the inside channels. I know there are drain channels there, but I'm wondering if this is normal. I will say, I never felt that good about how the new runs went in, as there was a gap around the center sash. Maybe I did sometime wrong, but that did seem like the only way they could go in -- that hole/gap does need to be there for the sash to pass through it. I could pull them again if need be, but would obviously like to avoid this.
Btw, the seam for run is on the rear vertical edge, which I think is correct and that did require they be trimmed as they were a a few inches long (which also seemed weird).
I've attached some photos.
Btw, the seam for run is on the rear vertical edge, which I think is correct and that did require they be trimmed as they were a a few inches long (which also seemed weird).
I've attached some photos.