Finally got started on soa and went to set pinion angle. I originally planned on setting at 0 then backing off 2. But then I got to thinking about it, and if I put in the antiwrap bar, should the angle still be -2(since the axle will not be allowed to wrap)? If this is a dumb question I am sorry, just dont want to cut and weld anymore than I have to. Also I failed to take a pic of or measure the rear end before I cut the purches off and am not sure of the spacing from the back side of flanges(had planned to use brake line clamps as reference). If somebody could post some pics or #s. I would greatly appreciate it. Thanks in advance, and as always u guys are awesome!!!