Rear load proportioning valve?

Discussion in '100-Series Cruisers' started by Pskhaat, Oct 29, 2005.

  1. Pskhaat

    Pskhaat

    Messages:
    2,631
    Likes Received:
    2
    Joined:
    Aug 19, 2003
    Location:
    Morrison Formation
    Am I not supposed to have one on my 1999? ...I don't unless I'm going blind and getting more stupid by the day?
     
  2. powderpig

    powderpig SILVER Star

    Messages:
    1,022
    Likes Received:
    16
    Joined:
    Jul 12, 2005
    Location:
    Boulder Foothills, CO
    4 channel ABS versus the three channel of older 80 series stuff. No need for a PPV on the braking system. later robbie
     
  3. 100 TD

    100 TD

    Messages:
    2,081
    Likes Received:
    17
    Joined:
    Mar 3, 2004
    Location:
    OZ
    In the 2003 it is built into the master cylinder, PROPORTIONING AND BY-PASS VALVE (P & B VALVE) that is, so I expect it is probably the same in your 99 if you have the expensive pressure accumulator/electric motor type master cylinder.

    Front brake caliper pressure...............Rear brake caliper pressure
    2,256 kPa (23 kgf·cm2, 327 psi).........2,452 kPa (25 kgf·cm2, 356 psi)
    4,413 kPa (45 kgf·cm2, 640 psi).........3,334 - 3,727 kPa (34 - 38 kgf·cm2, 484 - 540 psi)
    7,845 kPa (80 kgf·cm2, 1,138 psi)......5,197 kPa (53 kgf·cm2, 754 psi)
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.