Rear heater motor hole cover? (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 9, 2009
Threads
68
Messages
749
Location
avon,nc/courtland,va
What has everyone done to fill the hole under the seat after deleting rear heater motor
 
I cut the lid of a pickle jar to fit, covered that with a piece of a rubber boot to fit then glued and riveted to the floor.
Works great years later.
 
ISO-butyl rubber. (2) 6x6” squares. One for the top and one fir the bottom.

CA5875ED-7F53-49DA-A405-E8B20D32663D.jpeg


915000CD-6347-48CD-B14E-04F286987560.jpeg
 
Cut some metal, could have been an old license plate... Used rivnuts and secured the plate on top with polyurethane and Philip screws
 
Cut piece of aluminum drilled some holes, screwed her down with some rtv on it for proper squeeze out. Then more rtv cause you can never have enough rtv

AED81628-D740-4393-967D-FD742042858C.jpeg
 
Cool thanks all. Kinda what I was thinking. Figured I’d ask in case there was some genius method or a part number that goes in there
 
I once tried to find an rubber grommet/plug that would fit the hole but no luck so used some Dynamat/Hushmat type sound dampener as mentioned by NLXTACY above.

Maybe someone with more skills could find a plug that fits possibly from another vehicle (Toyota, Land Cruiser, or other) or a generic plug??
 

Users who are viewing this thread

Back
Top Bottom