Just fabbed some barn doors and installed a rear hatch on my original hard top. These replaced the ambulance doors.
I have searched up and down and can't find the measurements for where to mount the strut mounts. I can figure out the strikers location based on where the hatch lies, but I don't know how far above the strikers(or the bottom of the hard top) and at what angle to drill the hole into the jam for the strut mounts.
If anyone can measure this for me off their rig I would appreciate it. There Are two mounting holes for the strut mounts but are they horizontal to the ground?
Thanks
I have searched up and down and can't find the measurements for where to mount the strut mounts. I can figure out the strikers location based on where the hatch lies, but I don't know how far above the strikers(or the bottom of the hard top) and at what angle to drill the hole into the jam for the strut mounts.
If anyone can measure this for me off their rig I would appreciate it. There Are two mounting holes for the strut mounts but are they horizontal to the ground?
Thanks