Hello, my pinon is spacer 29.8" and fits perfectly with no discernable space on either side. Unable to fit the minimum fuelers gauge .0024" on either side. I can remove it with my fingers and a dental pick so it does not appear to be binding anything. Is it ok to leave this way? The FSM min standard .060mm/.0024" seems very thin. I have a fuelers gauge at .002 and it's paper thin but im unable to insert it between the spacer on either side. So, I'm wondering if it really matters that mine is touching or could I get it milled. Also, is the FSM min standard measurement .060mm/.0024" just for one side? Or is it .060mm/.0024" for each side or axel end?
Just curious if less is better in this case and I shouldn't worry about it.
Lastly, does it hurt the temper of the steel to mill it again?
Thanks,
Dave
Just curious if less is better in this case and I shouldn't worry about it.
Lastly, does it hurt the temper of the steel to mill it again?
Thanks,
Dave
Last edited: