Rear Control Arm ID help, need bushings! (1 Viewer)

[Elkwagn]

One of my Rear LCA bolts came out on a recent run, and when I noticed the inner sleeve was missing from the bushing as well. I did not install these, came on the rig when I purchased it, wondering if someone can ID them so I can get new bushings!! I suppose its possible that stock bushings may press right in?

 

[Rwhat]

They look stock with a weld in adjuster kit. The lower control arms definitely look stock by the way they are bent.

Edit, the upper doesn’t look stock axle side. The ears on the upper mount are bent from possibly a different width bushing and the mount being bent in from tightening it.

 

[Elkwagn]

Are they grey from the factory? The uppers definitely are aftermarket, the welds are done by machine and perfect

 

[Squeegee]

Those look stock. But the upper control arms been modified.