rear body mounts (1 Viewer)

[RUSH55]

Sah-weet dude!!

 

[NookShneer]

Is that a cabin air filter? My 60 is getting weak in the knees just thinking about that.

 

[xtiaan2000]

New Mexico Mark came up with it. I figured now was the time to make something up. Now I guess I will have a clean dustless cabin.

 

[xtiaan2000]

I have these speed hit gauges, you know like everyone else does, and I noticed that it has blinker and Brights lights on the face. Has anyone been running those and are they bright enough or should I put indash lights?

 

[Megadoomer]

I use them and they work just fine. The only issue is at 70 mph the needle is over the left turn signal and its harder to see. I basically cruise at 70. Its only an issue because my blinker switch doesn't always work so I rely on the flasher to know it is doing it's job.

 

[scrapdaddy]

I put in other lights and I can't remember why.

 

[xtiaan2000]

Got this before the COVID shutdowm.

 

[scrapdaddy]

I know I'm old with only one good eye, but what am I looking at? Looks like you have a fire in your shop.

 

[PabloCruise]

Fabiddy fab

View attachment 2440416View attachment 2440417View attachment 2440418


Thanks Abcruiser!

Ooh! Ready to start taking pre-orders? Sign me up!

 

[PabloCruise]

New Mexico Mark came up with it. I figured now was the time to make something up. Now I guess I will have a clean dustless cabin.

AKA @abqcruiser

 

[PabloCruise]

I know I'm old with only one good eye, but what am I looking at? Looks like you have a fire in your shop.

I think he installed a sauna/steamroom...

 

[J Mack]

Got this before the COVID shutdowm

I just got the green one last week.

 

[xtiaan2000]

I wish I had gotten the green one!

 

[xtiaan2000]

Been busy. Got some great help from TachedOutoffroad and Lowtideride and put together this picture story.

 

[xtiaan2000]

 

[PabloCruise]

Another 80-frame Piggy?!?

 

[xtiaan2000]

Now I know why Briveganbj42 went with two holes instead of 6- slot of welding! Have never been good with just going out and practicing running beads so I got some good practice! Someday I hope to run lines like Trail Taylor!
Got within four hole of finishing and ran out of gas :/

 

[xtiaan2000]

Now further thinking about it if I want to get beads like Trail Taylor I had better start just running beads.
Cause it don’t look as cool after I have been through with a welder!
I’ll show a pic after I have done a run over with a grinder

 

[WarDamnEagle]

Apparently you were too tired to take a photo.

 

[TachedOutOffRoad]

I can neither confirm nor deny my part in this as an enabler.


great work!