Hello, folks. I am in the middle of repacking my front bearings and I am having trouble getting the old oil seal off the hub on the back side of the rotor? The writeup says to pry it out with a screwdriver but I am not sure how to do it without damaging anything. Do I wedge the screwdriver between the edge of the abs sensor teeth and the seal or put the screwdriver on the inside of the hub to try and pop it out?
Also I assume I need to remove the hub from the rotor to get the rotor turned?
Thanks guys!
Also I assume I need to remove the hub from the rotor to get the rotor turned?
Thanks guys!