Ok...I stripped the rear interior plastic panels out of my LC for several reasons including trying to determine where the copious amounts of dust have been getting in.
Noticed on each side of each rear fender down low behind the Slee rear bumper "wings" are two oblong holes recessed into the fender itself approximately 1.5" wide x 4" long or so. It appears there are supposed to be plastic (?) body plugs here. But my FSM, on-line OEM parts breakdown and the local Toyota dealer can not turn up anything that is supposed to plug these holes.
These holes vent directly to the rear interior of my LC...my dust source! The trailer shop installed my 7-pin and brake controller by routing the wires through this hole...
Can someone that has a Slee bumper (you won't be able to see these holes/plugs with the factory bumper) take a peak and see if you have plugs filling these holes for me pelase?
Thanks,
Dan
Noticed on each side of each rear fender down low behind the Slee rear bumper "wings" are two oblong holes recessed into the fender itself approximately 1.5" wide x 4" long or so. It appears there are supposed to be plastic (?) body plugs here. But my FSM, on-line OEM parts breakdown and the local Toyota dealer can not turn up anything that is supposed to plug these holes.
These holes vent directly to the rear interior of my LC...my dust source! The trailer shop installed my 7-pin and brake controller by routing the wires through this hole...
Can someone that has a Slee bumper (you won't be able to see these holes/plugs with the factory bumper) take a peak and see if you have plugs filling these holes for me pelase?
Thanks,
Dan
Last edited: