Question: Self made sliders - How Far Below Rocker Panels (1 Viewer)

[67cruiser]

Hey folks,

I'm in the middle of building a set of sliders for my 80 Series.

I'm using 1/4" 2"x2" for the main rails.

I'm curious on how far below the rocker panel should I mount them. I know there needs to be room for them to flex in the event of a hard drop, but I'm not sure just how far down below.

I could use your help

Is an inch sufficient?

 

[george_tlc]

I've got maybe 1/2" clearance on mine. But... it all depends on how secure/stiff the outriggers to the sliders are - if they can pivot a fair bit, then that will dictate how far the slider rail can move on a hit.

Of course even if the slider makes contact with the bottom of the rocker - it is more a spread hit/push and that would be less damaging or of concern. And the body is on rubber mounts, so that push would also be somewhat soaked up.

cheers,
george.

 

[67cruiser]

Thanks George!

That's helpful.

The plates to the frame are 3/16", and the connecting pieces from the plates to the rails are the same 1/4" 2"x2" square tubing.